The scroll wheel I created in assessment 2 is the same one I used but I managed to recycle the part however I just made it bigger to suit the mouse I was creating.
I didnt change much on the chipboard however I had to alter it so that bigger scroll wheel could fit easily. Also, I edited a few of the holes on the chipboard as you can see in the image below.
Final product of the edited scroll wheel:
For the laser piece all I did was created a bit longer at the base so it sits flush with the bottom housing
I also edited the dome piece which you can see internally
Piecing the assembly together I made sure there was enough clearance for the scroll wheel and the laser piece inside the mouse.
No comments:
Post a Comment