Below is a surface extrude that I created to which will provide a smooth surface on the base of the top housing.
After trimming the surface, below you can see there is a small gap which I was aiming for.
Using a surface loft I'm now trimming the front end of the top housing to give it a smooth flush profile.
Because I had trouble due to an error with combining the loft with a subtraction to get rid of the lip piece I simply mirrored the left half (which was successful because the right side wasnt) and then subracted it from there, leaving a smooth lip finish.
All I had to do now was to split the button pieces to give the left and right finger grooves model definition.
No comments:
Post a Comment